30-day returns
Free shipping within the U.S.
30-day returns
Free shipping within the U.S.
30-day returns
Free shipping within the U.S.
30-day returns
Free shipping within the U.S.
30-day returns
Free shipping within the U.S.
30-day returns
Free shipping within the U.S.
Made to be seen up close
A closer look

Made to be seen up close

Every fixture we make is built to hold attention at arm's length as well as from across the room. Below are the details worth noticing on this one.

Design notes

Three details worth a closer look

What separates this one from a standard brass chandelier.

01
A Sunburst Pressed Into the Base

A Sunburst Pressed Into the Base

The underside of each shade carries a radiating cut pattern, so the brightest part of the glow sits at the centre and fans outward — the shade is doing the shaping, not just holding the light.

02
Petal Rim, Not a Straight Edge

Petal Rim, Not a Straight Edge

The shade flares open in soft scalloped waves rather than finishing in a plain circle, so it reads as a flower head opening upward and never as a plain cone turned on a lathe.

03
Solid Brass, Not Plated Tube

Solid Brass, Not Plated Tube

The arm, cup and backplate are solid brass throughout, so the weight is in your hand the moment you lift it, and the finish wears into the metal rather than off it.

◆ Complete the Look

Pairs
Well With

A room reads as designed when the pieces share a finish. Start here.

02

Craftsmanship

Brass keeps a record of everything done to it —
every cut, every pass of the wheel.

Brass That Isn't Just a Colour

Most fixtures sold as brass are iron wearing a brass coat — the colour is sprayed on, and it sits on the surface.

We work brass as metal. It gets cut, formed and joined as itself, and the finish comes from the surface underneath rather than from what's on top of it.

That decision changes everything downstream.

In the Workshop

The Long Way

Nothing here is finished in a single pass.

Each fixture goes through cutting, forming, joining and polishing as four separate stages, with the piece checked between each. Slower than finishing it all at the end, and the reason the surface holds up.

View more same‑craftsmanship lamps

01

Cut

Sheet and tube cut to size from stock.

02

Form

Spun over a form, then trimmed at the lathe.

03

Join

Brazed, then the seam dressed back flush.

04

Polish

Buffed on the wheel until the surface carries an even tone.

The Samu Difference

Why Choose SamuLighting

Free U.S. Shipping

On every order, with no minimum.

30-Day Returns

Straightforward returns and refunds.

Secure Checkout

SSL-encrypted payment at every step.

Finished by Hand

Every fixture inspected before it ships.